Brewing Two Cups Of Coffee; Brewing With Pre-Ground Coffee; Drawing Hot Water - Rotel AroMatica Mode D'emploi

300701 AroMatica755_Inhalt.qxd
• Just before the coffee cup is filled to the desired amount, turn the water amount
adjustment knob (3) slowly to the left until the machine stops brewing.
• Now you can read on the display how much water your cup requires.

3.4 Brewing two cups of coffee

Two millings are automatically done one after another for 2 cup operation.
• Place both prewarmed cups under the coffee outlet (8).
• Select the desired coffee strength and water quantity for one cup.
• Press the 2 cups selection button (6)
• The coffee machine now begins brewing and makes 2 cups of coffee one after
another.
☛
You may interrupt the process at any time by pushing either the 1 cup (5) or 2
cup selection knob (6).
☛
If it happens that the water or coffee beans run out right between two millings
or the trays must be emptied, this will be indicated and the second cup of
coffee will not be made. Follow the instructions for that symbol and then press
only the 1 cup selection knob (5) for the second cup of coffee.

3.5 Brewing with pre-ground coffee

• First set the water amount adjustment knob (3) for the amount of water desired for
one cup of coffee.
• Open the cover to the well for coffee grounds (20).
• Fill one level spoonful of ground coffee using the measuring spoon for ground
coffee (23) and close the cover. The display shows Powder is READY.
• Place your cup under the coffee outlet (8) and press the selection button for 1 cup (5).
☛
If the powder well is opened by accident, or if a brewing button is not pushed
after the grounds have been filled, the coffee machine will be automatically rin-
sed through the coffee outlet (8) one minute after the cover is closed and will
then be ready for operation.
Please note:
The ground coffee well is not for storage. Therefore you should never place more than
one portion in the well and always use fresh or vacuum-packed grounds from milled
beans. Instant coffee may not be used.

3.6 Drawing hot water

• Place your cup under the jet (12).
• Turn the steam/hot water dial (11) to the right.
• Fill your cup with the desired amount of water and turn the dial (11) back to 0.
☛
Caution: Very hot water and danger of burns! The water from the jet can
spray around. Touch only the black plastic part of the jet.
30
21.9.2010 13:40 Uhr Seite 30