Drawing Steam; Foaming Milk/Hot Milk - Rotel AroMatica Mode D'emploi

300701 AroMatica755_Inhalt.qxd

3.7 Drawing steam

• Place the cup with the liquid to be warmed up under the black swivel jet (12).
• Press the steam preheating button (10).
• As soon as the system is ready, STEAM is READY and TURN valve appear in the display.
• Make sure that the «Cappuccinatore» control knob (12a) is pointing to the neutral
position (steam symbol).
• Turn the steam/hot water dial (11) to the right. Please note: Water will first come out
and then steam.
• By turning back the dial (11) to 0, the process is stopped.
• Press the steam preheating button (10) and the coffee machine will be reset for
normal operation.
☛
You can make steam for up to two minutes. The machine will then turn off auto-
matically. By turning the knob (11) back and forth, you can continue the process.
☛
Caution: Very hot steam and danger of burns! Only touch the jet on the black
plastic part!

3.8 Foaming milk/hot milk

Using the special foaming tool «Cappuccinatore» (12), wich you will find in the welco-
ming pack, you can foam or heat up fresh milk directly in your cup.
• Mount the «Cappuccinatore» to the steam jet.
• Inserts the hose (12f) into the receptacle with milk and place the cup under the
steam/hot water jet (12).
• Press the steam preheating button (10).
• As soon as the system is ready, STEAM is READY and TURN valve appear in the display.
• Foaming milk: turn the «Cappuccinatore» control knob (12a) all the way to the left,
pointing to the symbol «foam/cappuccino».
• Hot Milk: turn the «Cappuccinatore» control knob (12a) all the way to the right, poin-
ting to the symbol «hot milk/café latte».
• Turn the steam/hot water dial (11) slowly to the right.
• The milk is soaked up and fed into the cup as foam or hot milk.
• End this process by closing the steam / hot water dial (11) and turning the
«Cappuccintore» control knob (12a) to the 0 position (steam symbole).
☛
You can make steam for up to two minutes. The machine will then turn off auto-
matically. By turning the knob (11) back and forth, you can continue the process.
TIP: Dried residue on the foaming tool and jet is difficult to remove. You should the-
refore clean it immediately after it has cooled off:
• Fill a container with cold clean water and dip the inlet hose (12f) into it.
• Place and empty container under «Cappuccinatore» jet (12) and turn the control
knob (12a) all the way to the right.
• Now draw steam (as described in points 3.7/3.8) until only clean water/steam comes out.
Please note: For optimal cleaning the «Cappuccinatore» must be dismantled from
time to time (see picture 12 on page 5) and its parts rinsed under fresh, cold water.
21.9.2010 13:40 Uhr Seite 31
31