Dhollandia DH-SM.20 Instructions De Montage page 63

EN
M
•
Option S255 [See Fig. 6.13]: these buffers are designed
for side-mounted sliding tubes on truck chassis.
•
They can be adjusted over a range H1 [See Fig. 6.13].
They are normally bolted to the rear most mounting brack-
et for the sliding tubes, but can also be welded or bolted
to the vehicle chassis itself.
•
Option S256 [See Fig 6.14]: these buffers can be used on
both types of alu sliding tubes, and can be adjusted over a
range H2.
•
These buffers [1 in Fig. 6.14] are mounted inside the track
of the sliding tubes, behind the end stops for the work
position [2 in Fig. 6.14]. They can only be used when the
end stops in the sliding tubes are mounted at a minimum
distance L=200 mm from the rear of the sliding tubes.
•
Option S256.ST [See Fig. 6.15]: these buffers are de-
signed for under-mounted sliding tubes on semi-trailer
chassis.
•
They can be adjusted over a range H3 [See Fig. 6.15].
They are normally bolted to the rear most mounting brack-
et for the sliding tubes, but can also be welded or bolted
to the vehicle chassis itself.
DHOLLANDIA
6.13
!
6.14
2
1
6.15
!
63
!
2
1
!
!
2
1