Table des Matières
Publicité
EN
M
Adjustments, and fastening of the slide plates
§5.6 -
•
For HTL with SIDE-mounting, and premounted slide
plates [See Fig. 2.6], the gap between the slide plates and
the chassis is covered by adjustable mounting brackets.
[See Fig. 5.24]. HTL types concerned: DH-SM, SMP,
SV, ...
•
With Bolt-on or premounted slide plates, mount the sliding
tubes as close as possible to the vehicle chassis. [See
Fig. 5.25]
•
HTL for UNDER-mounting are equipped with bolt-on slide
plates [See Fig. 2.5], the position of which can be adjusted
to the chassis width of the vehicle [See Fig. 5.26]. HTL
types concerned: DH-SMR, DH-SSUR.
•
Here, the adjustment available on the mounting brackets
is used to adapt the HTL to the width of the lower flange of
the I-beam of the vehicle chassis [See Fig. 5.27].
DHOLLANDIA
5.24
EX.
5.26
EX.
47
5.25
5.27
EX.
Publicité
Table des Matières
