Télécharger Imprimer la page

Publicité

Liens rapides

Mounting Instructions
MM.8.F04.S
Rev. 0
FORD TRANSIT L4
OV
Side/Rear installation | Lift type: DH-C(H)001.03.01
FWD/RWD/AWD | Single/Double wheel | WB= 3750 | OV= 1931
WB
FORD TRANSIT L3
Side/Rear installation | Lift type: DH-C(H)001.03.01
FWD/RWD/AWD | Single/Double wheel | WB= 3750 | OV= 1208
FORD TRANSIT L2
Side/Rear installation | Lift type: DH-C(H)001.03.01
FWD/RWD/AWD | Single/Double wheel | WB= 3300 | OV= 1208

Publicité

loading

Sommaire des Matières pour Dhollandia DH-C001.03.01

  • Page 1 Mounting Instructions MM.8.F04.S Rev. 0 FORD TRANSIT L4 Side/Rear installation | Lift type: DH-C(H)001.03.01 FWD/RWD/AWD | Single/Double wheel | WB= 3750 | OV= 1931 FORD TRANSIT L3 Side/Rear installation | Lift type: DH-C(H)001.03.01 FWD/RWD/AWD | Single/Double wheel | WB= 3750 | OV= 1208 FORD TRANSIT L2 Side/Rear installation | Lift type: DH-C(H)001.03.01 FWD/RWD/AWD | Single/Double wheel | WB= 3300 | OV= 1208...
  • Page 2 TION : PRATIQUES IMPORTANTES ET CONSIGNES DE SECURITE. L’édition la plus récente de ce manuel peut être téléchargée via : www.dhollandia.com > sélection du pays et de la langue > téléchargements > instructions de montage > sélectionnez le manuel requis ...
  • Page 3 A fall of the wheelchair lift from the chassis can damage the wheelchair lift and / or vehicle chassis and can cause serious bodily injury or death to the operator and any bystanders.  Therefore, it is essential that the mounting plates are installed following the instructions of this manual. MM.8.F04.S page 3/10 Rev. 0 www.dhollandia.com...
  • Page 4 Scope of delivery MM.8.F04.S MM.8.F04.S page 4/10 Rev. 0 www.dhollandia.com...
  • Page 5 Use a vehicle lift to raise the vehicle so you are able to mount the lift. Remove the spare wheel or other parts that would interfere with the installation. Check the vehicle manufacturer’s guidelines when removing parts or making permanent changes. MM.8.F04.S page 5/10 Rev. 0 www.dhollandia.com...
  • Page 6 Integrated inside the rear bumper. Parts of the bumper need to be cut away but the lift will not protrude beyond the original vehicle dimensions and make it less likely to be damaged by speed bumps etc. (Recommended) This is only applicable on an L4 version. Contact your Dhollandia distributor in case of any doubts or questions.
  • Page 7 Situation 2 Make cut-outs in the rear bumper so that the lift can be nicely integrated in the bumper. 280mm 280mm 40mm 50mm 280mm 280mm MM.8.F04.S page 7/10 Rev. 0 www.dhollandia.com...
  • Page 8 Place the mounting plate against the chassis and screw the flange bolts into the fixation plate from step 3. Do not tighten the bolts completely as small position adjustments still need to be made. MM.8.F04.S page 8/10 Rev. 0 www.dhollandia.com...
  • Page 9 Only take out the ones that will be used to mount the cassette to the mounting plates. See step 8. For the second installation situation (see step 1): Take out the bolt that holds the gas spring and re-attach it after positioning the lift. Situation 2 MM.8.F04.S page 9/10 Rev. 0 www.dhollandia.com...
  • Page 10 Go over every step to make sure you did not forget to tighten any bolts. These fixations should be tightened with the correct torque. See page 3 for the overview. Situation 1 Situation 2 MM.8.F04.S page 10/10 Rev. 0 www.dhollandia.com...

Ce manuel est également adapté pour:

Dh-ch001.03.01Dh-c001.03