Dhollandia DH-SM.20 Instructions De Montage page 35

EN
M
•
Mount the sliding tubes [4 in Fig. 5.10] over the rollers on
the slide plates on the HTL frame [5 in Fig. 5.10]. Push the
tubes forward until the end stops [1 in Fig. 5.7-5.9] hit the
rear face of the slide plate [5 in Fig.5.10].
•
If the sliding tubes would hit the mudguard of the vehicle,
the air bag, or any other parts of the vehicle prematurely,
the position of the end stops [1 in Fig. 5.7-5.9] in the slid-
ing tubes, or the length of the sliding tubes can be adjust-
ed accordingly [See also Fig. 5.16].
•
Do not drill, weld, cut... any parts of the slide
tubes or the vehicle chassis, until the full
mounting position of the HTL has been validat-
ed and tested with positive result.
DHOLLANDIA
5.10
EX.
5
35
4