Table des Matières
Publicité
Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
NOTE: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
Filling the Clean Water Tank
The TGB 6055/100 is equipped with a large capacity clean water tank allowing for large areas to be covered in a single fill.
1
10
To fill the clean water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap (1). Pull out
hose. Open the stopper and place hose under water tap, or use a hose to commence filling. The tank can also be filled by unscrewing
the filler cap and using a bucket or similar container (2).
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water
tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
2
Machine Set-up Guide
Refit vacuum hose to the
Floor tool when finished.
T 01460 68600
11
Publicité
Table des Matières
