Fitting The Hose Guide; Hose U Bend Clip; Breakaway Floor Tool - Numatic TRO 650G / 200T Notice Originale

Machine Set-up Guide

Fitting the Hose Guide

The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched off.
If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
Refit vacuum hose to the Floor-tool when finished.
! !
Note:
DO NOT push the vacuum hose onto the Floor-tool with the Floor-tool in the raised position.
Breakaway Floor-tool
The floor-tool design incorporates a safety knock-off feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine movement.
To re-attach the floor-tool blade to its holder.
First loosen the retaining knobs on the floor-tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight. (See Fig.13).
13
12
www.numatic.co.uk