Receiver Selection And Installation Pnp - Horizon Hobby E-FLITE Turbo Timber Evolution 1.5m Manuel D'utilisation

EN

Receiver Selection and Installation PNP

The recommended receiver for this aircraft is the Spektrum AR637T. If you choose
to install a different receiver, ensure that it is at least a 6-channel full range
receiver. Refer to the manual of your chosen receiver for correct installation and
operation instructions.
AR637T Installation
1. Attach the appropriate control surfaces to the their respective ports on the
receiver using the table at the right.
2. Using high quality double-sided servo tape,(not included) mount the receiver to
the flat area behind the battery compartment, as shown. The receiver should
be mounted in the orientation shown, parallel to the length of the fuselage,
with the label facing up and the servo ports facing the rear of the aircraft. The
orientation of the receiver is critical for all AS3X and SAFE technology setups.
CAUTION: Incorrect installation of the receiver could cause a crash.
Antenna Installation
The AR637T receiver has a coaxial style antenna. We recommend installing the
antenna as far as possible from metal, batteries, or carbon fiber to maximize signal
reception performance.
NOTICE: Do not cut, kink, or modify the antenna. Damage to the coaxial portion
of an antenna will reduce the performance of the antenna. Shortening or cutting
off the 31mm tip will reduce the range.
6
Active portion
of antenna
BND/PRG = BIND
1 = Throttle
2 = Ailerons
3 = Elevator
Turbo Timber Evolution 1.5m
AR637T Port Assignments
4 = Rudder
5 = Lights
6 = Flaps