Menu Elements Reference - Wilo VeroLine-IP-E Série Notice De Montage Et De Mise En Service

8.7

Menu elements reference

No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
2.3.2.0 Δp-v gradient
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values sen-
sor (In1)
4.1.3.0 Power
4.2.0.0 Operating data
4.2.1.0 Operating hours
4.2.2.0 Consumption
Installation and operating instructions Wilo-VeroLine-IP-E, VeroTwin-DP-E
The following table gives an overview of the available elements of all
menu levels. The menu number and the element type are designated
separately, and the function of the element is explained. If applicable,
there is information about the setting options of the individual elements.
NOTE:
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to "ON".
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 83)
±
Setting/display of the control
mode
(for further information, see
chapters 6.2 "Control modes" on
page 65 and 9.4 "Setting the
control mode" on page 95)
Constant speed control
Constant control Δp-c
Variable Δp-v control
PID control
Setting the gradient of Δp-v
(value in %)
±
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode
Δp-c, Δp-v: Value H in m
PID control: Value in %
Current power input P
Display of operating data
Sum of the pump's active hours
of operation
(meter can be reset by infrared
interface)
Energy consumption in
kWh/MWh
Display conditions
Not displayed for all pump
types.
Not displayed for manual
control mode
in W
1
The operating data refer to
the electronic module cur-
rently being operated
English
87