Programming - socomec DIRIS Ap Notice D'utilisation

PROGRAMMING

1 HOW TO ACCESS PROGRAMMING MODE
KEYS INSTRUCTION
Press for 3 seconds,
PROG
then release.
NB : Enter the access code '100' to access programming, and proceed as follows:
Press once
Press once
2 PROGRAMMING THE NETWORK (nET)
NB: As a default setting, the network is configured as 4NBL (4 unbalanced wires with 3 CTs). If you want this setting,
press on . You will pass to the Ct programming line. If not, proceed as follows:
KEYS INSTRUCTION
Press once
Press once
Press once
38
DISPLAY COMMENT
Confirm with
network programming (nEt).
DISPLAY COMMENT
To display flashing 4NBL
Press again for:
2BL
3BL
3NBL
4BL
ou
Press again for:
3NBL
3BL
2BL
1BL
and pass to
SOCOMEC - Ref. : 875 510A