socomec DIRIS Ap Notice D'utilisation page 46

Press once
NB: If the value is changed during operation, the number of pulses needs to be up dated on the device connected to
this output.
15 PROGRAMMING N° 2 PULSE OUTPUT DURATION (OUt 2 DUR)
NB: The default setting is 100 ms (DUR 100). If you want this value, press
line programming (COM ADR) if the communication module is connected or you will return to the network type pro-
gramming line. If not, proceed as follows:
KEYS INSTRUCTION
Press once
Press once
Press once
Press once
16 PROGRAMMING THE COMMUNICATION ADDRESS (COM ADR)
NB: The address default setting is 5 (ADR 5). If you want this value, press
programming (COM BDS) If not, proceed as follows:
KEYS INSTRUCTION
Press once
Press to decrement or
Press once to confirm
Press once to pass to speed programming (COM BDS)
NB: the address can vary between 1 to 255.
46
to increment the selected digit value
Confirm value.
Press on to pass
programming (DUR)
. You will pass to communication address
DISPLAY COMMENT
to display flashing the first digit
Press again for:
300,400,500,600,700,800 and
900 ms
or
Press again for:
800,700,600,500,400,300, and
200 ms
Confirm time.
Press on
tion programming (communication
module connected) or return to
network programming.
. You will pass to communication speed
DISPLAY COMMENT
to display flashing the 1st digit (press
twice and three times for the 2nd and
3rd digit) or press
left.
to pulse duration
(OPTION)
to pass to communica-
(OPTION)
to return to the
SOCOMEC - Ref. : 875 510A