Publicité
5. Screw in the adjusting bolt on the brake
caliper by hand until it feels tight, then
screw it out 1/8 turn. Tighten the adjusting
bolt locknut to the specified torque.
Tightening torque:
16 Nm (1.6 m·kg)
WARNING
Operating with improperly adjusted brakes
could cause the brakes to malfunction result-
ing in reduced braking performance. This
could increase the chance of a collision or acci-
dent. After adjusting the parking brake, block
the rear of the machine off the ground and
spin the rear wheels. Check to make sure there
is no brake drag. If brake drag is noticed, per-
form the adjustment again.
8-73
Publicité
Chapitres
Dépannage
