Maintenance To Be Performed By The Operator - Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with removable bowl SPI 160-300 A HYBRID

MAINTENANCE TO BE PERFORMED BY THE OPERATOR

These operations and checks are very simple and can therefore be performed by the user, fol-
lowing the instructions below.
Once a day:
Check the efficiency of the protections and safety devices by operating and inspecting them.
MAINTENANCE TO BE PERFORMED BY SERVICE PERSONNEL AUTHORISED BY THE
MANUFACTURER
Due to their delicate and complex nature, these operations and checks must be performed by
the manufacturer or qualified/specialist personnel.
Once a month:
Check the efficiency of the safety devices
Check the condition and positioning of the bowl guide rollers (instructions follow)
Once every six months:
Adjust the spiral arm drive belt tension (instructions follows)
Adjust the bowl drive belt tension (instructions follows)
Check the electrical equipment
Check that the tool is correctly fixed
Check possible sliding of the moving wheel (corrective instructions follow)
check the hydraulic unit oil level (it must be at least ¾ of the tank)
It is good to periodically lubricate the mechanisms of movement of the trolley through the grea-
se nipples. Two grease nipples are located in the front of the trolley close to the two front rollers
and two are accessing from the two holes in the side of the trolley and lubricate the two rear rol-
lers (Figure 40).
48
Figure n°40