Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance page 21

PROCEDURES FOR UNLOADING THE MACHINE USING A CRANE OR HOIST
Unloading personnel must be equipped with chains or ropes compatible with the weight and di-
mensions of the machine to be moved and in compliance with current safety regulations.
IMPORTANT WARNINGS !
- The slings must comply with ISO 4878 - ISO 9351 standards.
- Use the sling only if the label containing all the manufacturer information is affixed to it and
the capacity is clearly visible.
- Inspect the slings before all lifting operations. Do not use them if they are damaged, cut or
worn.
- Follow the load factors indicated for the various standardised configurations.
- Use adequate protection for lifting loads with sharp edges.
- Do not twist or knot the sling.
- Insert the other ends of the slings in the lifting equipment hook.
- Before moving the machine, ensure that there are no persons nearby.
- Carefully follow the unloading procedures described below.
1. remove the cover screws as per figure n°10
2. lift the rear cover
3. lean with care the cover
4. lift the machine:
- machine with jointed trolley : pass the belt in the front part of the central tube (Figure n°
11).
- pass the belts in the two eyebolts on the side of the head attached to the top of the col-
umn (Figures n ° 12 - 13).
Figure n° 11 Figure n° 12
English
Figure n° 10
Figure n° 13
21