Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance page 14

Instruction for use and maintenance
Spiral mixer with removable bowl SPI 160-300 A HYBRID
The machine conforms to:
▪ the Directive 98/37 CEE
▪ the Directive CEM 89/336 CEE
▪ the Directive BT 73/23 CEE
▪ the specific product standard EN 453 dated August 1999 where the major apllicable stan-
dard are listed.
The machine complies with the laws in effet when it was delivered.
To adapt the equipment to any subsequent modification of standards is under the responsability
of the user. In this case, he has to ask the manufacturer whether a modification is necessary.
PREVENTIVE MEASURES AGAINST MECHANICAL HAZARDS
TOOL (SPIRAL ARM) OPERATING AREA
(Figure n° 5 zone 1)
The bowl is protected in the front part with a stainless steel closed protection and in the rear
part with a flour protection sheet.
The head and its protection opening is temporized as per EN 453 to let the toll stops in 4 sec-
onds from the opening of the machine head.
SPACE BETWEEN BOWL AND STRUCTURE (Figure n° 5
zone 2)
It conforms to the specific product standard EN 453.
MECHANISM OF BOWL MOVEMENT (Figure n° 5 zone 3)
Parts in movement advised by warning stickers in order
to maintain the safety.
POSITIONING AND ADJUSTING MECHANISMS
(Figure n° 5 zone 4)
All motions of the machine are essentially made by hold-to-run
push buttons) and doesn't present risks for the operator.
Note: the operator must be sure there is no person near the machine.
Remove the guards with the specific tools, to accede to the moving elements of the transmission
for inspection, cleaning and maintenance purpose.
BOWL GUIDE DEVICE (figure n° 5 zone 5)
The zone is protected by fixed guards as per EN 453.
In any case we suggest to not insert the fingers in that zone to avoid possible crushing
14
5
1
3
control devices
Figura n° 5
4
2
(double