Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance page 37

When the "start" key is pressed, the automatic cycle starts: the machine starts in first speed
and the display indicates the remaining operating time (decremental).
With the machine operating in first speed the "bowl-inversion" command is enabled.
When the related key is pressed, the red led comes on, the bowl stops and after a pause of 1.5s
the machine inverts the movement of the bowl. This interval is not calculated by the timer. The
same thing happens when the key is pressed again and the inversion is de-activated).
The first speed display shows the remaining time.
Whenever the "bowl-inversion" key is pressed, the first speed timer is temporarily locked for the
time indicated above (1.5s).
Once the time in first speed has elapsed, the machine switches automatically to second speed:
the first speed display remains set to zero while the second speed display begins to decrement.
During operation of the machine it is possible to modify the 1
lowing limits:
minimum time in 1
st
zero-set but not otherwise;
the 1 and 2 speed time cannot be modified simultaneously.
st nd
The modifications made during operation are not stored.
When the "stop" key is pressed, the machine stops and the display-timers lock at the time re-
maining up to that point.
When the machine is stopped in 1
from the moment when it was interrupted until it completes at least the minimum time (2 se-
conds or 2 minutes).
Once the minimum operating time in 1
the 1 speed display you can set the time up to zero and switch to 2
st
remaining time in 1
If the "emergency button" is pressed, the machine stops and the display-timers show a code
that corresponds to the message "emergency pressed" ("---" "---").
When the emergency button is released, the display-timers show the time remaining up to that
moment.
When the bowl-protection is raised with the machine operating, the machine stops and the
display timers show the time remaining up to that moment in blinking mode. When the protec-
tion is closed, the display-timers show the time remaining up to that moment (in continuous no-
nintermittent mode).
In these last three conditions, since the timer that measures the 1
set to zero, we can have the following situations:
If the stop has occurred with the machine in 1
by pressing the "start" key it is possible to continue operation; the machine restarts in 1
(in this case the display-timers do not set to zero but continue to decrement the time).
By pressing the "stop" key, the display-timers return to the initial values and it is possible to
start a new cycle.
If the stop has occurred with the machine in 2
by pressing the "start" button it is possible to continue operation: the machine restarts in 1
speed for the duration of the 1
display-timer is updated to the minimum operating time) and then switches automatically to 2
speed (once the minimum time in 1
speed, i.e. if the min. time has already elapsed, the 1
speed, when restarted, it will resume operation in 1
st
speed after which the machine automatically switches to 2nd speed.
st
speed minimum time (2 seconds) (in this case the 1
st
speed has elapsed, it resumes decreasing the 2
st
speed has been completed, via the "down" key below
st
speed:
st
speed:
nd
and 2 speed times with the fol-
st nd
speed time can be
st
speed, or complete the
nd
speed minimum time has
st
English
speed
st
speed
st
st
speed
st
nd
speed
nd
37