Preparing For Pumping; Installation Of The Program Card - Medela Symphony Mode D'emploi

6. Preparing for pumping

Warning
26
l Only use the power cord that comes
with the Symphony.
l Make sure the voltage of the power cord
is compatible with the power source.
i
Info
Optional for pump with battery:
l The built-in battery must be charged for
12 hours on receipt of the device.
l The pump can be used during charging.
l If the pump is to remain unused for a
long time, charge the battery every two
months (for 12 hours each time).
l The optimum service life of the battery is
achieved if it is not fully discharged on a
regular basis or if the pump is charged
while not in use.
Pumping time
(fully charged battery)
Charging time
(for full charge)
approx. 60
min.
12 hours
6.1 Installation of the program
card
1
The program card must be inserted
in the card compartment on the
back of the breast pump. For more
information on the use of the card
and the selection of the appropriate
program, see chapter 7.2.
3
To remove, unscrew the card and
cord protector and slide out of the
guide rail.