Preparing For Pumping; Install Program Card - Medela Symphony Mode D'emploi

6. Preparing for pumping

Warning
18
l for chapter 6.2 Mains operation:
Only use the power cord that comes
with the Symphony.
l Make sure the voltage of the power cord
is compatible with the power source.
i
Info
l Only use the pump with the appropriate
program card (Standard or Preemie
Optional for pump with battery:
l Built-in battery must be charged for
12 hours on receipt of the device.
l The pump can be used during charging.
l If the pump is to remain unused for a
long time, charge the battery every two
months (for 12 hours each time).
l The optimum service life of the battery is
achieved if it is not fully discharged on a
regular basis or if the pump is charged
while not in use.
Pumping time
(fully-charged battery)
Charging time
(for full charge)
*).
+
approx. 60 min.
12 hours

6.1 Install program card

1
Insert program card
(Standard or Preemie
compartment on the back of
the breastpump.
3
To remove, unscrew the card
and cord protector and slide
out of the guide rail.
) in card
+