Preparing For Pumping; Assembly Of Breastpump Kit - Medela Freestyle 27260 Mode D'emploi

4. Preparing for Pumping

Parts you will need for this step:
• breastpump • breastshields
• bottles
and lids
NOTE
l Use Medela original accessories only.
Warning: Using non-Medela original accessories with your Medela
breastpump represents a health risk.
l Check breastpump kit components for wear or damage before use and
replace if necessary.
l All components must be completely dry before use for proper performance
and to prevent damage to the breastpump.
CAUTION
l Wash hands thoroughly with soap and water before touching the breast and
breastpump parts.
INFO
l Carry out all the steps with care and assemble the breastpump kit correctly
for optimum performance.
16
• membranes • tubing
• connectors • Back
caps

4.1 Assembly of breastpump kit

1
2
Wash hands before Carefully insert the light
touching breastpump, kit yellow membrane into the
and breasts and avoid base of the connector.
touching the inside of
bottles or lids.
4 5
Push the breastshield onto Screw bottle into connector. Insert the short tubing into
the connector.
7
Insert the long tubing into
the motor unit.
Questions? www.medela.ca, info@medela.ca or 1-800-435-8316
3
Fasten the back cap to the
connector
I Make sure that all 3 snaps
(top & side) are engaged.
6
the back cap as far as it
will go.
17