Operation Via Push Buttons; Three Digit Led Display - SKF LAGD 1000 Mode D'emploi

4.1.1 Operation via push buttons

Push button

4.1.2 Three digit LED display

During normal operation, the display is off. It is activated by briefly operating one
of the two push buttons. It is used for displaying current values and preset parameters.
In addition, the display is used for operator prompting during programming of
operating parameters.
Display Function
t = TIMER
PA = PAUZE
c = COUNTER
PA = PAUZE
t = TIMER
CO = CONTACT
c = COUNTER
CO = CONTACT
SKF LAGD 1000
Operating possibilities
• Operating the button during PAUSE, will initiate an
intermediate lubrication cycle
• Fault messages are acknowledged and cleared
• Automatically activates the display in display mode
• Calls up the next parameter in programming mode
• Increases the displayed value by 1
• Automatically activates the display in display mode
• Calls up the last parameter in programming mode
• Decreases the displayed value by 1
• Change between programming and display mode
• Confirm entered values
Description
The control unit
operates as a time
controlled contact
maker (TIMER) and is
in the PAUSE mode
The control unit
operates as a contact
counter (COUNTER) and
is in the PAUSE mode
The control unit
operates as a
timecontrolled contact
maker (TIMER) and is
in the pump running
mode (CONTACT)
DO NOT USE
• Part of lubrication cycle
Entered and displayed
value in hours
• Part of lubrication cycle
• The device counts the
pulses from an external
contact maker and
compares them with the
preset values
• CONTACT = time during
which the pump delivers
• Entered and displayed
value in minutes
21