SKF LAGD 1000 Mode D'emploi page 5

machinery to form a machine. Its startup is prohibited until conformity of
the overall machine has been established in accordance with the
appropriate accident prevention regulations, in particular in
implementation of the Use of Work Equipment Directive. The harmonized
standards applied here are, in particular DIN EN 809, DIN EN ISO
12100-1 and DIN EN ISO 12100-2.
• That as regards EC Pressure Equipment Directive 97/23/EC the unit may
only be used for its intended purpose and in accordance with the information
contained in the documentation.
The following must be observed in this connection:
• The products are neither designed nor approved for use in conjunction with
Group I fluids (hazardous fluids), as defined by Article 2, Par. 2 of Directive
67/548/EEC dated 27th June 1967.
• The products are neither designed nor approved for use in conjunction with
gases, liquefied gases, pressurized gases in solution, vapors and fluids with
a vapor pressure exceeding normal atmospheric pressure (1013 mbars) by
more than 0.5 bar at the maximum permissible temperature.
• When used as intended the products supplied by us do not reach the limit
values cited in Article 3, Par. 1, Number 1.1 to 1.3 and Par. 2 of Directive
97/23/EC. They are therefore not subject to the requirements set forth in
Appendix I of the Directive. They are consequently not provided with a CE
mark in respect to Directive 97/23/EC. They are classified by us in keeping
with Article, 3 Par. 3 of the directive.
Nieuwegein, the Netherlands,
December 2006
SKF Maintenance Products
Sébastien David
Manager Product Development and Quality
SKF LAGD 1000 5