Maintenance And Care; Maintenance Intervals; Warranty (Europe) - DT SWISS O.D.L Mode D'emploi

Masquer les pouces Voir aussi pour O.D.L:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
7

Maintenance and care

7.1

Maintenance intervals

Task
Full service completed by a DT Swiss service center.
Small service (if necessary completed by a DT Swiss service center)
See Technical Manual at www.dtswiss.com
Check the fork for damage.
If there is any damage apparent, contact the DT Swiss service
center.
Check the fastening is correct.
Check the functionality.
Clean with a soft sponge and a suitable cleaning agent, especially
in the area around the wipers.
Do not use high pressure cleaners or aggressive cleaning agents!
7.2
Disposal and environmental protection
The legal provisions concerning disposal apply. Essentially, waste of all kinds must be avoided
or recycled.
Any waste, cleaning products or liquids of any kind must be disposed of in an environmentally
responsible manner.
8

Warranty (Europe)

In addition to the general warranty required by law, DT Swiss AG based in Biel/Switzerland pro-
vides a guarantee for 24 months from the date of purchase. DT Swiss AG shall reject any liabil-
ity both for indirect damage caused by accidents and for consequential damage.
Any contradictory or extended national rights of the purchaser are not affected by this war-
ranty. Place of performance and jurisdiction is Biel/Switzerland. Swiss law shall apply.
Submit any warranty claims to your retailer or a DT Swiss service center. Any defects recognised
by DT Swiss AG as a warranty claim will be repaired or replaced by a DT Swiss service center.
Warranty and guarantee claims can be made only by the original purchaser with a valid sales
receipt.
There shall be no claim under the guarantee for:
• Normal wear and tear caused by use of the components
• Incorrect assembly
• Incorrect or non-existent maintenance
• Incorrectly completed repairs
• Use of unsuitable products
• Modification of components
• Incorrect use or misuse
• Use other than its intended correct and proper use
• Carelessness
• Leasing, commercial use, or use in competitions
• Damage caused by accidents
• Delivery and transport damage
• Modification, defacing, or removal of the serial number
20
Interval
Annually or after
200 operating hours
50 operating hours
Before and after each
ride
Before each ride
Before each ride
After each ride

Publicité

Table des Matières
loading

Table des Matières