Service And Care; Disposal And Environmental Protection; Warranty (Europe) - DT SWISS HUBS Manuel D'utilisation

4.3 ASSEMBLING THE CASSETTE
1. Clean the freehub surface. Aluminium freehubs should not be greased. Steel freehubs, on the
other hand, must be.
2. Clean the cassette. There must be no dirt between the individual cogs in the cassette.
3. Assemble the cassette according to the manufacturer's specifications.
4. Tighten the lock ring to 40 Nm.

5. SERVICE AND CARE

Task
Maintenance of the hub (see Technical Manual available at www.dtswiss.
com)
Under normal operating conditions
In case of extreme operating conditions (regular journeys in dust, rain,
snow, or in case of frequent transport while raining)
Check the tightening torques
• Center Lock adapter: 40 Nm
• Brake rotor screws: 6 Nm
• Lock ring on the cassette: 40 Nm
Check the functionality of the rear wheel hub.
The engagement of the rear wheel hub must operate perfectly!
Check the hub for damage.
Clean with soft cloth and a suitable cleaning agent.
→ Do not use high-pressure cleaners or aggressive cleaning
agents!

5.1 DISPOSAL AND ENVIRONMENTAL PROTECTION

The statutory regulations shall apply. Whenever possible, avoid creating waste.
Waste, especially carbon, lubricants, cleaners and any other fluids must be disposed in an
environmentally compatible manner.

6. WARRANTY (EUROPE)

Warranty conditions can be found at www.dtswiss.com
HUBS - User Manual V2020.05
Interval
Annually
3 months
20 operating hours
before each ride
After each ride
After each ride
9