General Information; Correct Use - DT SWISS O.D.L Mode D'emploi

Congratulations on the purchase of your new DT Swiss O.D.L fork! You have purchased a
quality product made by DT Swiss.
1

General information

This user manual is intended for the user of the fork. It includes information on the assembly,
maintenance and care of the fork along with the provisions of the warranty.
For further information and activities refer to www.dtswiss.com.
The manual must be read and understood by the user before using the component. Third-party
users must also be informed about the following provisions. Keep this user manual safe in case
you need to refer to it later.
2 Safety
DANGER
Incorrect handling, installation, maintenance or servicing can lead to accidents causing
severe injuries or death!
• Compliance with the following provisions is a prerequisite for accident-free use and
faultless functioning.
• Assembly and maintenance of the fork requires a basic knowledge of handling bicycle
components. If in any doubt, consult your retailer.
• The fork should be used only in accordance with its intended purpose. Otherwise the
user shall assume full responsibility.
• The fork must be compatible with all parts of the bicycle.
• Maintenance and repair of the fork must only be carried out by a trained specialist.
• None of the add-on parts must have any sharp edges.
• Only use original DT Swiss accessories and spare parts.
• The fork must not be changed or modified.
• The fork must not be used if it is damaged or there are any signs of damage. If in any
doubt, consult your retailer.
2.1

Correct use

This fork is intended for use as front wheel suspension and shock absorption on a bicycle. The
maximum system weight (driver, bicycle, equipment and luggage) is 130 kg.
This fork must only be used under the conditions of category 3 as defined in ASTM F2043-13.
Otherwise the user shall assume full responsibility.
11