DT SWISS O.D.L Mode D'emploi page 16

4 Using the DT Swiss shock pump
On forks that have been purchased as aftermarket components, the DT Swiss shock pump is
part of the supplied package.
1
2
The DT Swiss shock pump has a pressure gauge (1) which can be used to precisely adjust the
fork's pressure. A release valve (2) allows the pressure in the fork to be reduced. A valve lever
(3) on the pump head (4) allows the shock pump to be unscrewed without any loss of pressure.
Operating the shock pump
A
Screw the pump head (4) fully onto the valve on the fork.
B
Close the valve lever (3) (push the lever towards the valve) and pump up the fork.
Closing the valve lever (3) opens the valve on the fork.
Pressing the release valve (2) allows the pressure in the fork to be reduced.
C
Open the valve lever (3) (push the lever towards the pump tube).
Opening the valve lever closes the valve on the fork. No air is able to escape from the
fork when the pump is unscrewed.
D
Unscrew the pump head (4) from the valve on the fork.
14
A
3 4
B C D