Maintenance And Care; Warranty (Europe) - DT SWISS R 535 ONE Mode D'emploi

6

MAINTENANCE AND CARE

Task
Service completed by a DT Swiss Service Centre
Small service (if necessary completed by a DT Swiss Service Centre)
See Technical Manual at www.dtswiss.com
Check the rear shock for damage
Check the fastening is correct / check tightening torques
Check the functionality
Clean with a soft sponge and a suitable cleaning agent, especially in
the area around the wipers
Do not use high pressure cleaners or aggressive cleaning agents!
Disposal and environmental protection
The legal provisions concerning disposal apply. Essentially, waste of all kinds must be avoided or recy-
cled.
Any waste, carbon, cleaning products or liquids of any kind must be disposed of in an environmentally
responsible manner.
7

WARRANTY (EUROPE)

In addition to the general warranty required by law, DT Swiss AG based in Biel/Switzerland provides a
guarantee for 24 months from the date of purchase. DT Swiss AG shall reject any liability both for indi-
rect damage caused by accidents and for consequential damage. Any contradictory or extended nati-
onal rights of the purchaser are not affected by this warranty. Place of performance and jurisdiction
is Biel/Switzerland. Swiss law shall apply.
Submit any warranty claims to your retailer or a DT Swiss Service Centre. Any defects recognised by
DT Swiss AG as a warranty claim will be repaired or replaced by a DT Swiss Service Centre.
Warranty and guarantee claims can be made only by the original purchaser with a valid sales receipt.
There shall be no claim under the guarantee for:
• Normal wear and tear caused by use of the components
• Incorrect assembly
• Incorrect or non-existent maintenance
• Incorrectly completed repairs
• Use of unsuitable products
• Modification of components
• Incorrect use or misuse
• Use other than its intended correct and proper use
• Carelessness
• Leasing, commercial use, or use in competitions
• Damage caused by accidents
• Delivery and transport damage
• Modification, defacing, or removal of the serial number
Interval
Annually or after
200 operating hours
50 operating hours
Before and after each ride
Before each ride
Before each ride
After each ride
19