Replace Canister - Medela Thopaz+ Mode D'emploi

8 Replace canister

WARNINGS
The canister is replaced on the basis of a visual check or according to the instructions on
the Thopaz + display (warning signal). Wear gloves for all operations.
CAUTIONS
Canister changes shall be recorded for safety reasons.
36 |
Replace canister
1. Prepare sterile canister (with/without solidifier).
2. Clamp off patient tubing with the tube clamp.
3.
3 sec.
4.
5.
6.
3.1 Switch Thopaz + to
Standby by pressing
"Standby" for longer than
3 seconds.
4.1 Release the canister by
pressing the release
button.
4.2 Remove canister.
5.1 Unpack the canister.
5.2 Position the openings at
the top and attach the
bottom part of the canister
to Thopaz + .
6.1 Push the canister into
Thopaz + until you hear a
click.
Safety related tip
Using a 2 l canister
refer to chapter 7.3.1
– Using 2 l canister.