Switch Thopaz + On - Medela Thopaz+ Mode D'emploi

Switch Thopaz + on

7.4
Important: Do switch Thopaz + on before connecting the
system to the patient.
1.
If the selftest is not successful, follow the troubleshooting
instructions on the display and refer to chapter 12 – Trouble-
shooting and alarms.
2.
Thopaz + will issue a new patient number.
yes
The therapy time and history data will start from
0 (recommended for a new patient).
Note: Once the patient number reaches 100 it
automatically defaults back to 1.
no The patient number remains unchanged (recom-
mended for the continued treatment of the same
patient). The data history and the therapy time are
retained.
3.
1.1 Press [ ] to switch
Thopaz + on. A selftest
starts.
1.2 Check acoustic signal
(beep).
2.1 Confirm whether a new
patient is connected or
not. The patient number is
important for therapy time,
history data and data
transfer to the PC.
3.1 Check canister matching:
detected canister size vs.
attached canister.
No match: dispose
canister.
Preparation for use/operating instructions
| 27