Cleaning The Turbo Nozzle - Cleanmaxx NK-165 Mode D'emploi

• If necessary, wipe down the device and accessories with a soft, damp cloth and then
wipe them dry.
• Remove hair and fl uff from the nozzles.
• Check the mains adapter (1) and the mains cable for damage at regular intervals.
Emptying the Collecting Container and Cleaning the HEPA Filter

Cleaning the Turbo Nozzle

To make it easier to clean, the brush (33) can be removed from the turbo nozzle (25):
27
1. Switch off the device.
2. If dry dirt has been sucked up, hold the device over a
dustbin and detach the motor unit (13) from the collect-
ing container (5). To do this, grip the collecting contain-
er (5), press the release button (9) and detach the motor
unit (13).
3. Pull the fi lter protection (6) and the HEPA fi lter (7) out of
the collecting container (5).
4. Empty the collecting container (5).
5. Tap out the fi lter protection (6) and the HEPA fi lter (7).
Clean the HEPA fi lter (7) with a soft brush if necessary.
6. In the case of wet dirt, rinse the collecting container (5),
the fi lter protection (6) and if necessary the HEPA fi lter (7)
with clear, lukewarm water. CAUTION: Do not use any
cleaning agents!
7. Let all parts dry completely in the air before you reas-
semble them. CAUTION: Never assemble wet or damp
components or attach them to the motor unit (13)! The
device is assembled in the reverse order.
1. Press the release button (30) on the turbo nozzle (25) and
detach it from the frame (24).
EN