Cleaning The Housing And Nozzles; Cleaning The Floor Nozzle - Cleanmaxx PC-U001 Mode D'emploi

8. Place the HEPA fi lter holder onto the cyclone insert.
9. Place the lid onto the dust container so that the line marked on the edge of the lid
is next to the
towards the
10. Insert the dust container into the device. Make sure that it audibly locks in place.
If the fi lters are damaged or worn, you can order new fi lters at
www.service-shopping.de.

Cleaning the Housing and Nozzles

• If necessary, clean the housing using a slightly damp, soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals. The brush can be re-
moved from the fl oor nozzle to make it easier to clean (see below).

Cleaning the Floor Nozzle

07517_de-en-fr-nl_A5_V1.indb 27 07517_de-en-fr-nl_A5_V1.indb 27
3. Pull the HEPA fi lter holder (21) away from the cyclone
insert (22). Please note: The HEPA fi lter is attached to
the fi lter holder and cannot be taken out of the holder!
21
4. Carefully remove the cyclone insert from the dust con-
tainer.
5. Tap out all the parts over a dustbin and brush off the
22
loose dirt.
6. If necessary, clean the cyclone insert and dust container
with a damp cloth.
7. When all parts are dry, insert the cyclone insert back into
the dust container. Make sure that you insert the three
catches on the edge of the cyclone insert correctly into
the right notches in the dust container.
symbol on the dust container. Then turn the lid as far as it will go
symbol.
1. Remove the fl oor nozzle from the motor unit. To do this,
secure the fl oor nozzle (e.g. with your foot), press the
release button below the motor unit and pull the motor
unit up and away at the same time.
2. Place the fl oor nozzle down so that the bottom (brush)
is pointing upwards.
3. The clip that fi xes the brush in place is secured to the
fl oor nozzle with a screw. Unscrew the screw using a
cross-head screwdriver.
4. Remove the clip.
5. Grip the brush at the end below the clip and pull it out of
the fl oor nozzle.
6. Now you can remove hair, dust etc. from the brush.
7. When you want to assemble it, fi rst place the brush on
the small wheel in the fl oor nozzle and then press the
other end of the brush into the holder.
8. Insert the clip and screw it in tight.
27 EN
29.04.2016 12:38:57 29.04.2016 12:38:57