Cleaning The Hepa Filter; Cleaning The Brush Nozzle - Cleanmaxx T-110-80 Mode D'emploi

Cleaning the HEPA Filter

The HEPA dust fi lter is located in the dust container.
6. If necessary, thoroughly rinse the HEPA fi lter and the dust fi lter insert with clear,
lukewarm water. CAUTION: Do not under any circumstances clean the fi lter in a wa-
shing machine or dishwasher! Then shake off any excess water and let the fi lter and
the fi lter protective frame dry completely in the air before you insert them both again.
7. Place the HEPA fi lter back onto the dust fi lter insert.
8. Insert the dust fi lter insert together with the HEPA fi lter back into the dust container
and turn it tight.
9. Then place the dust container back into the device. Make sure that the dust contai-
ner locks in place correctly.

Cleaning the Brush nozzle

Remove hair and fl uff from the nozzles at regular intervals.
1. To make it easy to clean the brush nozzle, you can open
the nozzle: Open the dust compartment on the bottom of
the nozzle by pushing both hooks in.
2. To clean the brush, remove the upper part of the housing
carefully. You can now remove hair, dust, etc.
3. After cleaning, put the brush nozzle back together. The
dust compartment and the upper part of the housing must
engage audibly.
22
1. Remove the fl oor or tile nozzle as de-
scribed in the chapter "Attaching/re-
moving nozzles".
2. Turn the dust bin slightly to the left to
remove it from the main unit.
3. Pull out the dust fi lter insert together
with the HEPA fi lter.
4. Take the HEPA fi lter out of the dust
fi lter insert
5. Tap out the HEPA fi lter.