Emptying The Dust Container; Cleaning The Turbo Nozzle - Cleanmaxx PC-P008E Mode D'emploi

■ Only put the device back together once all parts are completely dry!
■ Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface. If needed, clean the housing with a damp, soft cloth.
The fi lter may lose some of its colour over time. This is normal and does not
have any adverse effect on function.

Emptying the Dust Container

closed
open
3. Push the release button on the dust container and empty it.
5. If necessary, clean the dust container and the dust fi lter with clean, lukewarm water.
NOTICE: Do not clean the HEPA fi lter with water!
6. Allow all parts to dry completely before assembling them.
NOTICE: Do not in any case insert the dust fi lter if it is still moist. Reverse
the steps to assemble them. Make sure that the catches on the dust container are
inserted into the corresponding recesses on the main unit. Otherwise, the dust
container will not correctly lock into the device.
Cleaning the Main unit, Articulated Suction Tube and Nozzles
• Wipe down the main unit (3), articulated suction tube and nozzles with a damp, soft
cloth if necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.

Cleaning the Turbo Nozzle

To make it easier to clean, the brush can be removed from the turbo nozzle (9):
25
1. Remove the dust container (7) from the main unit (3). Turn
it a little to do this. It is released from the main unit and
can be removed.
2. Hold the dust container over an open dust container. The
distance from the dust container should be as small as
possible so that the dust does not spread in the surround-
ing air.
4. Pull the fi lters out of the dust container: Turn the dust fi lter
approx. one quarter turn counterclockwise and remove
the dust fi lter with the HEPA fi lter. Knock all parts out over
a rubbish bin and brush them off if necessary.
1. Slide the latch fastener on the bottom of the turbo nozzle
towards the small wheel on the turbo nozzle.
EN