Cleaning And Storing The Device - Cleanmaxx NK-165 Mode D'emploi

EN
Handheld Vacuum Cleaner
1. Remove the cordless vacuum cleaner from the frame (24).
Floor Vacuum Cleaner
To operate the device as a fl oor vacuum cleaner, the cordless vacuum cleaner and the
turbo nozzle (25) must be inserted in the frame (24) (see the "Assembly" chapter).

Cleaning and Storing the Device

CAUTION!
■ Switch off the device before you clean it.
■ Keep the motor unit (13), the turbo nozzle (25), the mains adapter (1) and the mains
cable away from water or other liquids to prevent electric shocks.
■ Accessories that can be cleaned with water must be completely dry when they are
inserted back into the device.
■ The HEPA fi lter (7) is neither machine-washable, dishwasher-safe nor suitable for
tumble drying. Never clean the fi lter with soap or other cleaning agents to prevent
damage to the HEPA fi lter (7).
■ Only ever dry the HEPA fi lter (7) in the air, and never use a hair dryer to do so.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice and accessories. These could damage the surfaces.
• If the collecting container (5) is full (in the case of liquid up to the MAX marking) and
after each use, it needs to be emptied (see the "Emptying the Collecting Container
and Cleaning the HEPA Filter" section).
26
2. Place one of the nozzles into the suction opening (4). But
the cordless vacuum cleaner can also be used without a
nozzle.
3. Switch on the device: Slide the ON / OFF switch (11) to the
ON position.
4. Guide the nozzle or suction opening (4) over the surface
to be cleaned.
5. Switch off the device: Slide the ON / OFF switch (11) to the
OFF position.
1. Hold the turbo nozzle (25) with your foot and tilt the
frame (24) downwards. This will release the upright po-
sition.
2. Slide the ON / OFF switch (17) on the shaft (18) to the ON
position.
The cordless vacuum cleaner switches on. The brush (33)
in the turbo nozzle (25) rotates.
3. Guide the turbo nozzle (25) over the fl oor.
4. Switch off the device: Slide the ON / OFF switch (17) on
the shaft (18) to the OFF position.
5. To park the cordless vacuum cleaner, put the frame (24)
into the upright position. The joint of the turbo nozzle (25)
engages (upright position).