Angle Measurement; Distance Measurement - TOOLCRAFT LDM 60J Mode D'emploi

• Starting point: Tripod socket
• The reading contains the distance from the tripod
thread to the front.
• Starting point: Back of the device
• The device length is included in the measurement.

10. Angle measurement

• When being switched on, the product activates the angle
measurement mode.
• The cross hairs graphically show the deviation from zero.
• This display view also allows for measuring one single distance. To
do so, press the ON/DIST button (C) twice – one time to activate
the target laser (B) and a second time to measure the distance. The
reading is shown in the bottom of the display.
• Press the angle measurement button (H) once to enlarge the angle
measurement to the full size of the display (full screen).

11. Distance measurement

1. Briefly press the C/OFF button (F), in order to switch to standard
measurement mode.
2. Press the ON/DIST button (C) to activate the target laser (B).
3. Point the laser at a right angle at the target and hold the device as
still as possible.
4. Press the ON/DIST button. Shortly, a beep sounds and the reading
is shown on the display.
44