TOOLCRAFT LDM 60J Mode D'emploi page 53

4. Measure the first distance. The reading is shown in the white line.
5. Measure the second distance. Maintain a right angle. The reading is
shown in the violet line.
6. Measure the third distance. The reading is shown in the blue line.
7. The height between points 1 and 3 is calculated automatically and is
shown in the bottom line.
With three reference points (partial section)
1. Press the indirect measurement button (H) four times. A rectangular
triangle separated by a violet line appears left in the display.
2. Activate the target laser (B) by pressing the ON/DIST button (C).
3. Now measure the three necessary lengths. In regard to the right
order, refer to the following picture.
1 2
1 2
m m
m
m
m
53