Operation; Switching On/Off; Individual Distance Measurement - TOOLCRAFT 75 98 13 Mode D'emploi

9. Operation

a) Switching On/Off
• To activate the laser distance meter, briefly push the measuring button „
Then all display segments appear briefly; afterwards, a sound signal is audible and the laser is
activated. The laser distance meter is now ready for operation and a measuring process can
be started (see chapter 9. b).
If the laser is to be deactivated, briefly push the power button „ " (D). The laser is also
automatically deactivated after 30 seconds to save power.
• To switch the device off. keep the power button „ " (D) pushed for 3 seconds.
The laser distance meter switches off automatically after 3 minutes if no button is
pushed.
b) Individual Distance Measurement
• Switch on the laser distance meter with the measuring button „
a).
• If the laser lights up, place the lower edge of the laser
distance meter at one surface and point the laser beam
accordingly so that the distance can be measured.
• Now briefly push the measuring button „
measure the distance and display it in the bottom line
(4). The laser goes out.
• If a measurement is to be repeated, briefly push the
measuring button „
again.
After pushing the measuring button „
displayed.
The preceding measured value appears in the upper line (3), the current one in the
lower line (4). You can compare two distances or two measurements, for example.
• After briefly pushing the Power button „ " (D), the respective last measured value can be
deleted from the display.
" (B). The laser is now activated
" (B) again briefly, the distance is measured and
" (B) to
" (B).
" (B) first, see chapter 9.
31