TOOLCRAFT LDM 60J Mode D'emploi page 56

2. Activate the target laser (B) by pressing the ON/DIST button (C).
3. Then measure the required distance (hypotenuse; refer to the black
solid line in the following picture).
4. The reading is shown in the violet line.
5. The height between points 1 and 2 is calculated automatically and is
shown in the bottom line. This distance must be vertical, otherwise
the calculated value will be wrong.
6. The distance between the product and point 2 is calculated
automatically and is shown in the blue line. This distance must be
horizontally, otherwise the calculated value will be wrong.
56
1 2
1 2
m m
m
m