DS Produkte ZJ1002 Mode D'emploi page 33

Step 5
1 x no. 47 M 16
Step 6
1. Remove the locking screw (47) from
the top of the back rest.
2. Insert the perforated tube of the head
rest into the holder on the back rest.
3. Select one of the 3 possible height
settings (marked by a line on the per-
forated tube) and fi x the head rest in
place with the locking screw.
To adjust the device to your body size,
you can change the distance between the
seat and leg supports.
1. Remove the locking screw (47) from
the tube (3) which the seat is mounted
on.
2. You can now pull the perforated
tube (4) out a bit or push it further into
the tube. Select one of the 3 possible
length settings (marked by a line on
the perforated tube).
3. Use the locking screw to connect the
tube with the perforated tube.
33