DS Produkte ZJ1002 Mode D'emploi page 31

All device components are numbered in the chapter "Exploded view and part
list". The numbers specifi ed there also correspond to the numbering in this
chapter.
Step 1
1 x no. 31 Ø 8 x 80
Step 2
1 x no. 30 Ø 8 x 60
1. Fold up the back rest.
2. Insert the long bolt (31) through the
holes on the connecting piece and
the back rest frame. If necessary, the
back rest must be pushed a little bit
towards the seat so that the bolt can
be run through it.
• If you would like to pull the bolt back
out, push the catch on the bolt.
• Insert the medium bolt (30) through
the holes of the connecting piece and
the tube (3) which the seat is mounted
on. If applicable, lift the tube slightly
so that the bolt can be run through it.
• If you would like to pull the bolt back
out, push the catch on the bolt.
31