Mafell NFU 50 Consignes D'utilisation/De Sécurité page 34

NFU 50
8 Service and maintenance
MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.
8.1 Tool
Clean tools improve the milling quality. The resin should therefore be removed from the tools used on the
machine at regular intervals.
To remove the resin, soak the tool for 24 hours in kerosene or a commercially available resin-removing agent.
Replace damaged clamping screws and cutting elements in good time.
8.2 Storage
Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
34 12/2024