Mafell NFU 50 Consignes D'utilisation/De Sécurité page 33

NFU 50
9. Switch off the machine at the end of the milling
process.
Wait until the tool has stopped

completely. An "orange" signal of the
warning lamp tells you that the tool is still
rotating.
The machine can be removed from the

guide rail.
Machining with the guide rail J

completed.
Use the following procedure to work with the
guide rail K:
1. Secure the guide rail K from the special
accessories on the workpiece you want to
machine.
2. Engage the guiding groove of the machine in
the guide rail K.
3. Adjust the required depth of the machine.
4. Switch on the machine.
5. Push the machine steadily forward in milling
direction.
6. Switch off the machine at the end of the milling
process.
Wait until the tool has stopped

completely. An "orange" signal of the
warning lamp tells you that the tool is still
rotating.
The machine can be removed from the

guide rail.
Machining with the guide rail K

completed.
12/2024
Fig. 42: Guiding the machine along the guide rail
33