Mafell NFU 50 Consignes D'utilisation/De Sécurité page 31

NFU 50
7.8 Working with special accessories
Various special accessories are available for the machine. An overview can be found in chapter 10 Optional
accessories.
Some utilization methods are explained below.
7.8.1 Working with the roller edge guide
The roller edge guide I (special accessories) is used for working in parallel to an existing edge. The guide
fence can be mounted on the right (motor side) side of the machine. The adjustable distance on the right side
is 50 to 280 mm [2 to 11 in].
Use the following procedure to install the roller
edge guide:
1. Loosen the four wing screws 6.
2. Insert the roller edge guide I into the guide
provided for this purpose.
3. Tighten the four wing screws 6.
The roller edge guide is installed.

Use the following procedure to adjust the
milling range:
1. Loosen the four wing screws 6.
2. Adjust the roller edge guide I in the guide to
the desired offset.
3. Tighten the four wing screws 6.
The milling range is adjusted.

12/2024
Fig. 37: Installing the roller edge guide
Fig. 38: Adjusting the cutting width via the roller edge
guide
31