Mafell NFU 50 Consignes D'utilisation/De Sécurité page 29

NFU 50
Use the following procedure to adjust the depth
repetition stop adapter:
1. Lock the stop rod in the uppermost position
using the clamping lever 3.
2. Push the depth repetition stop adapter 12
forward.
3. Fold the depth repetition stop adapter 12
sideways.
The depth repetition stop adapter

automatically engages in its end position.
The depth repetition stop adapter is

positioned.
7.6 Adjustment for inclination work
For inclination and birthmouth cuts, the milling cutter can be set to any angle from 0° to 45°.
Use the following procedure to set the saw for
inclination and birthmouth cuts:
1. To incline the machine, put down and support
the machine so that the milling cutter can be
swiveled.
2. Release the clamping lever 10.
3. Use the scale 9 on the tilting segment to set
the angle.
4. Tighten the clamping lever 10.
The milling cutter is set to the desired

angle for inclination and birthmouth cuts.
12/2024
Fig. 33: Positioning the depth repetition stop adapter
Fig. 34: Setting the milling cutter for inclination and
birthmouth cuts
29