Mafell NFU 50 Consignes D'utilisation/De Sécurité page 26

You can fine adjust the offsets of the side guide. Different offsets can be set via the marks X and Y on the side
guide.
X = 625 mm with 60 mm milling head
Y = 600 mm with 46 mm milling head
Use the following procedure to adjust the
offsets at the side guide:
1. Loosen the locking screw 17 on the side guide
You can use the Allen key tip of the

position indicator to loosen or adjust the
screw.
2. Adjust the offset at the setting screw 25 to the
required mark.
3. Tighten the locking screw 17.
The side guide offset is set.

26
Fig. 28: Adjusting the offsets at the side guide
NFU 50
12/2024