Mafell NFU 50 Consignes D'utilisation/De Sécurité page 16

6.3 Chip extraction
For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The inner diameter of the hose connector is 58 mm [2.3 in].
6.4 Tool
The machine is equipped with a milling head for milling work. This tool is equipped with 12 replaceable carbide
inserts for milling operations.
Only the tools intended for this purpose by MAFELL may be used.
16
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health
damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.

Wear a dust mask during work.

Caution
Risk of injury from the tool
The carbide inserts on the tool are sharp. You can hurt yourself when you
work on the tool.
Be careful when you handle the tool.

Wear protective gloves when you handle the tool.

NFU 50
12/2024