Publicité
No showing on the display,
The chiller works
Error code E02 is displayed
Error code E03 is displayed
Error code E04 is displayed
Error code E06 is displayed
Error code E07 is displayed
Error code E08 is displayed
Paint leaks outside the pump
The pattern of the painted stripe
changes
dramatically
spraying, or the sprayer does not
turn
on
immediately
spraying resumes.
27
The display was damaged or had a bad
connection
Connection error
Pressure sensor failure
Contact Your Supplier
Alarm IPM
High pressure during cleaning
Low mains voltage
Pump seals are worn out
The pressure control switch is worn
during
and
causes
changes.
when
Check the connection, replace the display
Check the signal line
between the pressure sensor and the circuit
board (circuit board with connections for
mounting electronic components)
Check the pressure sensor
in the event of a poor connection or damage
Contact Your Supplier
Contact Your Supplier
Relieve pressure during cleaning
Check the power supply
Replace pump seals
Contact Your Supplier
excessive
pressure
WABRO Sp. z o. o.
ul. Arki Bożka 2A, Bytom
NIP: 6263044765 | Regon: 52012826
Publicité
