Publicité
The pump is running, but the paint
only drips or squirts when the gun
is running
The aggregate picks up the paint,
but it falls off when the gun is
opened
Leaks related to nozzle installation
The gun does not spray
Barrier to prevent painting
Thermal
overload
has
triggered
26
The pressure is set too low
The sealing ring in the pump is worn or
damaged
The suction pipe filter is clogged
The spray nozzle is clogged
The chiller filter is clogged
The spray gun filter is clogged.
The spray nozzle is too large or worn
Worn spray bar
Clogged suction pipe filter
Clogged gun filter or nozzle gasket
The paint is too heavy or thick
Worn V seal
Worn or damaged work valve
Incorrect assembly
Worn gasket
Clogged spray nozzle, gun filter, or
nozzle
Clogged filter
Nozzle in cleaning position
The pressure is set too low
The gun, nozzle or suction filter is
clogged.
Loose suction tube
Worn nozzle
Paint too thick
been
Overheated engine
Paint builds up on the engine
Device exposed to the sun
Slowly turn the pressure control knob
clockwise to increase the pressure setting,
which will turn on the motor and create
pressure.
Replace the O-ring
Clean the filter
Unclog or replace the spray nozzle
Clean or replace the filter
Clean or replace the gun filter
Replace the nozzle
Replace the nozzle with a new one
Clean the filter
Clean or replace the filter, or replace the
nozzle gasket. Keep extra filters handy
Dilute or strain the paint following the
manufacturer's recommendations
Replace
Replace the valve
Check the assembly
Replace the gasket
Clean or replace components
Clean or replace the gun or filter
Rotate the nozzle
Increase the pressure
Clean the filter
Tighten the suction pipe fitting
Replace the nozzle
Thin the paint if possible
Allow to cool for 15 to 30 minutes
Clean the engine of paint
Move the device to a shaded area
WABRO Sp. z o. o.
ul. Arki Bożka 2A, Bytom
NIP: 6263044765 | Regon: 52012826
Publicité
