Publicité
Sheets (MSDS) and stickers on paint and solvent containers. Follow the paint and solvent
manufacturer's safety instructions.
10.
There should be working fire extinguishing equipment on site.
11.
The sprayer generates sparks. If flammable liquid is used in or near the sprayer or for rinsing or
cleaning, keep the sprayer at least 6 m away from explosive vapors
ELECTRICAL SAFETY
1.
Power tool plugs must match the sockets. It is forbidden to modify the plugin in any way. Do not
connect any adapters (adapters) to grounded power tools. The use of unmodified plugs and fitted
outlets reduces the likelihood of electric shock.
2.
Grounded tools must be connected to a properly installed and grounded outlet in accordance
with all standards and ordinances. It is forbidden to remove the grounding plug or modify the
plug in any way. Do not use any plug adapters. If in doubt as to whether the outlet is properly
grounded, consult a qualified electrician. If power tools start to run incorrectly or break,
grounding provides a way for low-resistance electricity to be dissipated from the user.
3.
Avoid body contact with grounded surfaces such as pipes, heaters, refrigerators. When the user's
body is grounded, the likelihood of electric shock increases.
4.
Do not expose power tools to rain or moisture. Water entering the power tool increases the risk
of electric shock.
5.
Use cables as intended. Never use the wiring to carry, drag, or unplug the power tool from the
outlet. Keep the cable away from heat, oil, sharp edges, and moving parts. Replace damaged
cables immediately. Damaged or tangled cables increase the risk of electric shock.
6.
When using the power tool outdoors, use extension cords suitable for outdoor use. The use of
cables adapted for outdoor use reduces the likelihood of electric shock
HAZARD OF SUBCUTANEOUS INJECTION
A high-pressure spray can cause toxins to be injected into the body and cause serious injury. If this
happens, you should seek medical attention from your surgeon immediately.
1.
The gun must not be pointed at people or animals; They are also not allowed to be sprayed.
2.
Do not bring your hands or other parts of your body near the exhaust nozzle. For example, you
should not attempt to stop the leak with any part of your body.
3.
Always use the nozzle tip cover. Do not spray when the nozzle tip guard is not in place.
4.
WABROTECH nozzles should be used.
5.
Care is required when cleaning and replacing nozzle tips. If the tip of the nozzle becomes clogged
during spraying, perform a decompression procedure to turn off the unit and relieve pressure
before removing the tip of the nozzle for cleaning,
6.
Do not leave the appliance unattended when it is connected to the power supply or under
pressure. When the device is not in use, turn it off and perform the decompression procedure.
7.
Inspect hoses and other parts for damage. Damaged hoses or parts must be replaced.
8
.
WABRO Sp. z o. o.
ul. Arki Bożka 2A, Bytom
NIP: 6263044765 | Regon: 52012826
Publicité
