Publicité
3.
Remove the spray nozzle before rinsing. Hold the metal part of the gun to the side of the metal
bucket and use the lowest possible fluid pressure when rinsing.
4.
Never apply high pressure when cleaning. USE MINIMUM PRESSURE.
5.
Do not smoke in the shower/clean area. NEVER use cleaning solvents with a flash point below
60 degrees C. Some of them are: acetone, benzene, ether, gasoline, kerosene. To make sure,
contact your supplier.
CONNECTION TO THE POWER SUPPLY
The mains voltage must correspond to the voltage indicated on the rating plate of the appliance. Under
no circumstances should the tool be used if the power cable is damaged. A damaged cord must be
replaced immediately by an authorized Customer Service Center. Do not attempt to repair a damaged
cord yourself. The use of damaged power cables can lead to electric shock.
IMPORTANT: use only a three-wire extension cord that has a grounding plug with two pins and a hole
and a socket into which the appliance plug can be inserted, with two holes and a pin. Make sure the
extension cord is in good condition. When using an extension cord, you should be sure that it has
sufficient parameters to conduct the current that the device may draw. A cable with too weak parameters
will cause a drop in the mains voltage, resulting in power losses and overheating. It is recommended to
use a wire with a cross-section of 3 × 1.5 mm. If the extension cord is to be used outdoors, it must be
marked W-A after the wire type has been determined. For example, the designation SJTW-A would
indicate that the cable is suitable for outdoor use.
GROUNDING TIPS
WARNING: Installing the grounding plug inadequately increases the risk of electric shock.
1. Containers
When working with solvent-based materials
and oil-based fluids, only use conductive
metal containers and place them on grounded
surfaces such as concrete. Containers of
material should not be placed on surfaces that
are not grounding, such as rubber, cardboard.
12
2. Ground
Metal containers must be grounded by
connecting the earthing wire connecting the
container and the earth electrode.
WABRO Sp. z o. o.
NIP: 6263044765 | Regon: 52012826
ul. Arki Bożka 2A, Bytom
Publicité
